Professional HVAC Services in Davenport, FL

Performed a chemical cleaning of the condenser coil. Removed all condenser covers, thoroughly rinsed the coil, applied coil cleaner, and ensured all cleaner was fully washed off before reassembling the unit. Recommended removing and cleaning the blower wheel; customer approved. Pulled out the blower wheel, cleaned and sanitized it thoroughly. Applied microbial treatment and cleaned/sanitized the entire air handler cabinet, including the drain pan and accessible wiring. Installed a UV light system with a separate transformer. Tested UV operation and confirmed proper functionality. Tested full system operation, including: * System pressures * Subcooling and superheat * Temperature split * Compressor amperage * Fan motor amperage At this time, the system is operating properly. All components are clean, sanitized, and functioning within normal parameters.

Performed a diagnostic on a Boreal mini split system due to error code C0. Upon inspection, I checked system pressures and found the unit completely out of refrigerant, reading approximately 3 PSI. Based on the condition of the system, I recommended full equipment replacement. The customer agreed to receive a proposal. I contacted the office to submit the lead, and Kenneth provided the proposal to the customer. At this time, the unit is temporarily down and not operational.

Performed preventive maintenance on a package unit located in Franklin. Inspected and tested system operation in cooling mode. Checked system pressures and verified proper temperature split. Inspected electrical components including contactor and capacitor—both are operating within normal condition. Measured compressor amps, condenser fan motor amps, and blower motor amps; all readings are within manufacturer specifications. Cleaned and rinsed the condenser coil and removed debris from inside the condenser compartment to ensure proper airflow and efficiency. Cleaned the drain pan and flushed the drain line, then applied Viper treatment to help prevent buildup. Verified UV light is operational and functioning properly. Confirmed surge protector is installed and working as intended. At this time, the system is operating properly with no issues found.

Performed a diagnostic on a Tottukool air conditioning system due to the customer’s complaint that the air handler fan motor was running continuously. Upon inspection, I found that the customer had recently replaced the thermostat and wired it incorrectly. The electric heat wire (white wire) was connected to the wrong terminal (W1). Since this is a heat pump system, I relocated the white wire to the correct auxiliary heat (AUX) terminal. After correcting the wiring, the system began operating normally. I tested the system in cooling mode and checked system pressures, superheat, temperature split, compressor amperage, condenser fan motor amperage, and blower motor amperage. All readings were within normal operating range, and the system is running properly at this time. The customer expressed interest in a maintenance agreement. However, the property is co-owned with his brother, and he will need to discuss it with him before making a decision. The customer stated he may contact us i

Check system pressures and temperature split only per HO.

Performed maintenance on a mini split system. Checked amperage, pressures, and temperature in accordance with the data plate specifications. Cleaned and flushed the drain line to ensure proper drainage. Rinsed the condenser coil to remove debris and improve efficiency. Cleaned the air filter. System is operating properly at this time with no issues observed. Recommended installation of a surge protector for the system. Maintenance completed successfully.