Trusted HVAC Specialists in Davenport, FL

Performed preventive maintenance on a Carrier system. Tested system operation in cooling mode and checked system pressures, subcooling, superheat, temperature split, compressor amperage, condenser fan motor amperage, and blower motor amperage. Inspected all electrical components. The capacitor is operating within manufacturer specifications; however, the contactor is badly pitted and should be replaced to prevent potential system failure. Removed debris from inside the condenser and thoroughly cleaned the condenser coil by rinsing from the inside out and outside in. Cleaned the condensate drain line and drain pan and applied Viper treatment to help prevent future buildup. During the indoor inspection, bacterial growth was observed on the left side of the air handler cabinet. The existing UV light installation was found to be improper. The UV light currently covers only one side of the evaporator coil and is wired into the blower motor circuit, causing it to operate only when the fan

Performed diagnostic and found the condenser running, but the air handler was not operating. Upon inspection, I found the fan delay board defective. The replacement part is expected to be available by Friday. I discussed new equipment upgrade options with the customer, and she is interested in receiving a proposal. I contacted the office to create the lead, and Kenneth arrived on-site to assist with the call. I quoted a temporary repair option; however, the customer declined at this time. I also performed a complimentary leak search and did not find any refrigerant leaks. During the inspection, I found several additional issues that need attention: * Contactor is badly pitted and recommended for replacement. * Suction line insulation is missing and should be replaced. * Thermostat wiring has damaged insulation and needs replacement. * Drain line requires cleaning service. * Heavy bacteria growth is present inside the air handler and around the evaporator coil. I highly recommend

Performed comfort maintenance and checked system operation in cool mode. Inspected system pressures, subcooling, superheat, temperature split, compressor amps, condenser fan motor amps, blower motor amps, and electrical components. During the inspection, I found the capacitor is out of tolerance and recommend replacement to prevent potential system failure. I also found minor bacterial growth under the evaporator coil in the drain pan area. Recommend microbial treatment and installation of a UV light to help reduce biological growth and improve indoor air quality. Additionally, no surge protector was found installed at the condenser or gas furnace. Recommend installing surge protection to help protect the equipment from power surges and electrical damage. I replaced the air filter provided by the customer and tested the condensate safety float switch, which is operating properly. At this time, all system operations are running and cooling properly.

Cub club - 2019 Carrier - Maintenance complete: System running great on arrival. Refrigerant readings and air flow readings are good All amp draws in tolerance. *Contactor is very pitted and recommend replacing. Capacitor is rusted but in tolerance. Outside coil very clean. Evaporator coil has some buildup but affecting air flow readings. Blower wheel also starting to get buildup. Advised customer. Please remember regular filter changes every 3 days with a pleated MERV 8 Filter. Thank you for choosing Underwood AC!

Performed a diagnostic on a 5-ton gas furnace and air conditioning system. Found the condenser fan motor bearing seized and preventing proper operation. Property management was on site and approved the condenser fan motor replacement. I replaced the condenser fan motor, installed a new 5 microfarad capacitor, and secured the capacitor with a mounting bracket. During the unit inspection, I found the contactor badly pitted and recommended replacement. Property management did not approve the contactor replacement at this time and requested a proposal to be sent. Upon arrival, property management was already cleaning the system drain line and replacing the air filter. After completing the condenser fan motor replacement, I tested system operation and checked temperature split, compressor amperage, fan motor amperage, system pressures, subcooling, and superheat. All system operations are running properly and cooling good at this time. This air conditioning system is approximately 9 yea

Performed one-time preventive maintenance on a 3.5-ton Goodman system using R-22 refrigerant. During the inspection, I found the condenser coil heavily compacted with debris and recommended a chemical coil cleaning. Customer declined the coil cleaning at this time due to cost concerns and requested only the regular maintenance service. Inspected system components and found the contactor badly pitted. Capacitor tested within acceptable range. Evaporator coil inside the air handler is clean, and no bacterial growth was observed. Blower wheel is in fair condition and operating properly. Checked system operation in cooling mode and verified refrigerant pressures, subcooling, superheat, and temperature split. Also checked compressor amps, condenser fan motor amps, and blower motor amps. Performed drain line and drain pan maintenance, cleaned the system drain line and fan, and added Viper treatment. Customer had previously eliminated the normal drain routing, causing the drain to dischar

Performed diagnostic on a 2013 Trane gas furnace system. Verified that the unit does not have any type of manufacturer warranty remaining. During inspection, found the condenser fan capacitor completely failed on the fan side and the contactor badly pitted. Also found the condensate drain line extremely clogged and the supply plenum leaking air badly. Presented repair estimates to the homeowner for the identified issues. Customer approved drain line cleaning only at this time. Performed drain line cleaning and added Viper treatment. Flushed approximately eight gallons of water through the drain line until water was running clean and draining properly. Unable to open and inspect the evaporator coil case due to the refrigerant gas line blocking access. Homeowner was informed and acknowledged the limitation. After completing the drain cleaning and restarting the air conditioning system, found the fan no longer operating due to the failed capacitor. Homeowner was informed that the syste

Diagnosis on a 2021 system. Upon arrival, the system was operating with abnormally high refrigerant pressures. It appears the individual sent out by the owner severely overcharged the system. Recovered 6 pounds of refrigerant, and system pressures stabilized afterward. System is now operating properly at this time. System still appears to potentially have a refrigerant leak and may require a full leak detection in the future. Performed a complimentary electronic leak search on the evaporator coil and found no detectable leaks at this time. If the system freezes up again, there is most likely an active refrigerant leak within the system.

Performed diagnostic on 5-ton DuKing unit, installed February 2021. Verified system warranty and confirmed coverage expires in 2031. Customer reported water leaking inside the garage and found the return box fully soaked and wet from ongoing drainage issues. Performed inspection and found the drain line requiring cleaning. Quoted drain cleaning and customer approved repairs. Also found the air handler platform badly sinking, causing the drain line to lose proper pitch and contribute to drainage problems. I temporarily corrected the drain line pitch to restore drainage, but informed the customer this is only a temporary repair because the air handler platform remains soft and continues to sink. Recommended replacement and rebuild of the return plenum/return box due to water damage and condition. Also provided full repair recommendations including rebuild of the return plenum and return box, installation of a UV light, microbial treatment, and pull and clean of the blower wheel to addr

Diagnosis on 2023 Daikin Fit system. System was giving EF and B0 error codes. Found water residue in the float switch. Poured water down the drain line and found the drain line to be severely clogged. Completed lvl 3 drain line service and system is now operating properly at this time.