Professional HVAC Services in Davenport, FL

Service summary 2024 Goodman Owner stated system has moisture on outside walls of cabinet and was worried it may freeze up again. Found no moisture on arrival, system operating normally. Refrigerant and temperature show no sign of freezing, the filter was replaced last week. The air handler is located in garage which can get very hot, and tenant usually keeps tstat around 73-74. Advised owner that in on hot days it can be normal for system to sweat, especially in the areas that they noticed moisture.

Performed evaporator coil replacement on the downstairs HVAC unit. Pumped the refrigerant down into the condenser and flowed nitrogen while brazing to prevent oxidation inside the refrigerant lines. Replaced the evaporator coil and filter drier. Pressure-tested the system, then evacuated the system to 298 microns. Released the refrigerant back into the system and added 2.13 pounds of refrigerant. Verified that the refrigerant charge is set according to the manufacturer’s specifications. Checked system operation, including refrigerant pressure, subcooling, superheat, and temperature split. Also verified that the condensate drain is flowing properly. All system operations are running properly, and the system is draining properly at this time.

Performed a diagnostic on a 3.5-ton Lennox system. Found the condensate drain line clogged and the drain pan full of water and significant bacterial buildup. Provided the customer with a quote for drain line cleaning, which the customer approved. Cleared the condensate drain line using a drain snake and treated the drain line with Viper treatment. The customer also showed me water dripping from the return box. I removed the accumulated water from the return box. Advised the customer that the system is approximately 13 years old and is in poor overall condition, with significant corrosion. Due to the age and condition of the equipment, the customer requested a proposal for a new system. I contacted the office and created a lead for Kenneth. Kenneth worked directly with the customer, explained the replacement options, and presented the proposal. The customer approved a Premium Plus system replacement, scheduled for Tuesday. As a courtesy, today’s visit will be free of charge. No diag

Concerns notated. Recommendations & repairs needed: 1. Found contactor very pitted and needs replaced. 2. Microbial Growth present inside of air handler & , recommended microbial treatment and UV light. 3. Blower wheel extremely dirty, severely compacted. Strongly recommended pull and clean to relieve stress on attached blower motor.

Performed a diagnostic on the upstairs Goodman system, installed in 2021. Upon inspection, I found that the blower motor was not operating properly. Using my testing equipment, I determined that the blower motor module was defective. The motor would operate for approximately one second and then shut off. I contacted the homeowner and explained my findings. The homeowner approved the blower motor replacement. I replaced the existing motor with a new 3/4 HP blower motor and tested the system operation. During testing, I checked the system pressures and found the head pressure and suction pressure were equalized. I also heard the compressor attempting to operate when checking the common/suction port. The suction pressure was at 0 PSI, indicating a restriction in the refrigeration circuit. Further inspection of the outdoor unit found that the capillary tube connected to the TXV sensing bulb had become disconnected/broken. This is causing the TXV to remain closed and preventing refrigera

Performed a diagnostic on the downstairs 2.5-ton system, approximately 20 years old. Found the system drain line completely clogged. With the customer’s approval, I cleaned the drain line and drain pan using a drain snake and Viper treatment. After completing the cleaning, I tested the system and confirmed the drain is flowing properly. I explained to the customer the overall condition and age of the equipment. Both the upstairs and downstairs systems are approximately 20 years old, so I recommended considering replacement of both systems at the same time for better reliability and to avoid having one older system remain in service after replacing the other. The customer requested a proposal for a new system. I contacted the office and created a lead for Kenneth. I also took all necessary system measurements and documented the equipment information, electrical information, and breaker size for Kenneth. Kenneth came to the home and presented the customer with replacement options. The